Télécharger Imprimer la page

Dynex DX-WGRTR Guide De L'utilisateur page 7

Routeur sans fil g

Publicité

Les langues disponibles

Les langues disponibles

Product features
Back panel
#
Component
1
Wired computer
ports - Blue
2
Power jack
3
Modem port - Green This port is for connection to your cable or DSL modem. Use the cable that was
4
Reset button
1
3
Connect your wired (non-wireless) computers to these ports. These ports are RJ-45,
10/100 auto-negotiation, auto-uplinking ports for standard UTP category 5 or 6
Ethernet cable. The ports are labeled 1 through 4. These ports correspond to the
numbered LEDs on the front of the router.
The 5 V DC power supply plugs into this jack.
provided with the modem to connect the modem to this port. Use of a cable other
than the cable supplied with the cable modem may not work properly.
The Reset button is used in rare cases when the router may function improperly.
Resetting the router restores the router's normal operation while maintaining the
programmed settings. You can also restore the factory default settings by using the
Reset button. Use the restore option in instances where you may have forgotten your
custom password.
Resetting the router—Push and release the Reset button. The lights on the
router will momentarily flash. The Power/Ready light will begin to blink. When the
Power/Ready light becomes solid again, the reset is complete.
Restoring the Factory Defaults—Press and hold the Reset button for at least 10
seconds, then release it. The lights on the router will momentarily flash. The Power/
Ready light will begin to blink. When the Power/Ready light becomes solid again,
the restore is complete.
2
4
Description
7

Publicité

loading