Publicité
Les langues disponibles
Les langues disponibles
EN
22
Repairs
Your board comes with a repair kit as standard equipment.
1
Cut a patch out of the repair material and round off the corners. The patch
should overlap the damaged area by 1.3 cm on each side.
2
Apply adhesive to the underside of the cut patch and around the area to
be repaired. Too much glue will prevent proper repair.
3
Wait 2-4 minutes before gluing the patch to the damaged area.
4
Place a weight of approx. 1.3-2.3 kg on the spot so that pressure is
permanently applied for approx. 12 hours.
5
After the patch has dried, re-apply adhesive around the corners to seal the
patch completely. Allow to dry for another 4 hours.
Publicité
