Evaluating The Measured Data - cyclotest lady Mode D'emploi

Measuring the wake-up
temperature
Press the On/Off button to switch the
unit on. A short beep signals that the
thermometer is on. A visual full-seg-
ment check of the display is performed
at the same time.
The measured value of the last
measurement is displayed:
Then an internal test value of 37.00 °C
(± 0.02 °C) appears. The thermometer
switches into measurement mode.
The flashing "°C" in the display
indicates that the new measurement
has started.
The unit confirms
measurement has been successful
with a repeated beep and indicates
the measured temperature in the
display.
Please always
measurement has finished before
removing the thermometer from the
point of measurement. This can take a
few minutes in some cases.
The determined measured value
remains stored
measurement.
that the
wait until the
until the next
EN-22
Evaluating the measured
data
The unit switches itself off approx.
8-10 minutes after the measurement
has finished. You can also switch off
the thermometer yourself before this
by pressing the On/Off button.
Enter the measured values in a cy-
clotest® chart. Use a new chart for
each cycle.
Start the entries on the first day
of your regular period (= 1st cycle
day). Regular periods differ from
intermenstrual bleeding in that they
are accompanied by typical drop in
temperature.
Also make a note on the chart of
special factors and influences which
could alter the temperature:
Sexual intercourse (V), fever (E), taking
of medication/drugs (M) or sleeping
medication (S), insufficient sleep (wS),
change of climate (K), consumption of
alcohol (A), emotional/mental strain
(B) or physical exertion (kA).
Also make a note on the chart of
bleeding and mucus quality: regular
period (R), heavy, moderate, light
intermenstrual bleeding (sZ, mZ, gZ),
spotting (SB) and if possible also the
appearance and nature of the cervical
mucus.
EN-23