Uponor Smatrix Base Guide De Référence Rapide page 10

UK
Unregister one channel or system device
CZ
When a channel or system device is inaccurately
registered or if a thermostat registration needs to be
redone, it is possible to remove the current registration
DE
from the controller.
To unregister a channel:
DK
1. Enter registration mode. Channel 1 LED fl ashes red/
green, or the fi rst unregistered channel fl ashes red.
2. If a system device (timer etc) is to be unregistered,
EE
enter system channel registration mode. The power
LED fl ashes according to the pattern long blink,
short pause, long blink and channel 1 LED fl ashes
ES
red/green.
3. Use buttons < or > to move the pointer (LED
FI
fl ashes red) to the selected channel (fl ashes green if
registered) to unregister.
FR
4. Press the < and > buttons simultaneously for about
5 seconds until the LED for the selected channel
starts fl ashing red.
HR
Unregister all channels
HU When one or more channels are inaccurately registered,
it is possible to remove all registrations at the same
time.
IT
To cancel all channel registrations:
1. Enter registration mode. Channel 1 LED fl ashes red/
LT
green, or the fi rst unregistered channel fl ashes red.
2. Press the < and > buttons simultaneously for about
10 seconds until the LEDs for all channels except
LV
one turn off. The one remaining fl ashes red.
NL
NO
PL
PT
RO
RU
SE
SI
SK
1 0
QUICK GUIDE
Communications protocol
The system is based on a bus communications protocol
(requires the thermostats unique ID to be registered
to the controller), utilising daisy chain, direct or
star topology connections. This allows serial and
parallel connections, makes wiring and connection
of thermostats and system devices much easier than
connecting one thermostat per connection terminal.
The wide array of connection possibilities presented
with this communications protocol can be combined in
any way best suited for the current system.
Miscellaneous functions
See full manual for more information about
Autobalancing of actuators (eliminating the need of
manual balancing,on by default), Cooling, and Comfort/
ECO settings etc.
U P O N O R S M AT R I X B A S E · Q U I C K G U I D E