SOLAC CP7370 Mode D'emploi page 9

To remove the comb guide, simply
•
push upwards from one of the si-
des. Do not pull the teeth upwards.
To remove the guide comb, pull
•
upward.
USE:
The appliance can be used directly
•
connected to the mains or by using
his batteries.
Extend the cable completely before
•
plugging it in.
Connect the appliance to the
•
mains.
Make sure that the blades are co-
•
rrectly aligned.
Turn the appliance on, by using the
•
on/off switch.
Select the desired cutting height
•
using the comb height selector
Press it and adjust the height ac-
cording to the desired cutting len-
gth (F).
ONCE YOU HAVE FINISHED
USING THE APPLIANCE:
Turn the appliance off using the on/
•
off switch.
Unplug the appliance from the
•
mains.
Clean the appliance.
•
CLEANING:
Disconnect the battery charger
•
from the mains and allow it to cool
before undertaking any cleaning
task.
Clean the equipment with a damp
•
cloth with a few drops of was-
hing-up liquid and then dry.
Do not use solvents, or products
•
with an acid or base pH such as
bleach, or abrasive products, for
cleaning the appliance.
Never submerge the appliance in
•
water or any other liquid or place it
under running water.
During the cleaning process, take
•
special care with the blades, as
they are very sharp.
If the appliance is not in good con-
•
dition of cleanliness, its surface
may degrade and inexorably affect
the duration of the appliance's use-
ful life and could become unsafe to
us.
Clean the blades and the comb
•
guide with the cleaning brush. Re-
move the hairs from the blades and
from inside the appliance with the
brush. It is important to clean off re-
maining hairs after each use.
NEVER disassemble the blades
•
from the appliance for clean it.
HOW TO REMOVE THE
BATTERIES FROM THE IN-
TERIOR OF THE DEVICE:
CAUTION: It is important that the
•
batteries are fully discharged prior
EN