Specifications - Inepro PayMatic AD2400 Manuel D'instructions

Settings
Function P3, Display indication
Display indication, choice between 00 of --.
Setting "00": display during stand by one point (.), during the prior time, main time and post time two
hyphens will be displayed (--).
Setting "01": display indication in minutes
Function P4, Reduction of the main time
Setting "00": The reduction of the main time during the prior time is impossible
Setting "01": The reduction of the main time during the prior time is possible
Function P5, Pause during the main time
Setting "00": Pause during the main time impossible
Setting "01": Pause during the main time possible
Note, During a pause situation the remaining time will be intermittently indicated (if display indication is
activated (P3)). Note; this funcion works only with long distance board!
Function P6, Main time during the pause
Setting "00": Main time stops during the pause
Setting "01": Main time continues during the pause
Function P7, Main time reduction during the main time
Setting "00": The main time will be finished immediately when the down key is pressed.
Setting "01": It is possible to shorten the main time during the main time (by means of the down key).
When the main time is shortened it will always start with whole minutes.
Note: When activating this function, function P4 has to be connected as well (even if the pre-time is not
used).
Setting "02": The down key will be blocked during the main time. During the pre-time, it will function as
programmed in function P4.
Function P8, Payment during main time
Setting "00": Payment during main time is not possible.
Setting "01": Payment during main time is possible..
Note: The maximum amount of coin pulses can be programmed in function F4.

Specifications

Supply voltage for the network model:
Voltage range:
Current consumption:
Fuse
Supply voltage for the low voltage model
Voltage range:
Current consumption:
Maximum rupturing capacity of the relay:
Admissible rupturing capacity of the relay:
(ECOS module EM-14)
(ECOS module EM-13)
®
PayMatic AD2400(-B) Version 2.0 5-11-2007
- www.inepro.com
185 VAC - 240 VAC
25 mA maximum
500mA
12 VAC - 24 VAC
12 VDC - 35 VDC
250 mA maximum
16 ampere max.
with cosine phi= 1
16 ampere max.
with cosine phi= 1
-
18