Menuett 005908 Instructions D'utilisation page 11

1 Introduction
1.1 Product description
The product is a fruit and mushroom dryer with 5 trays and
a digital display.
1.2 Intended use
The product is intended to dry vegetables, herbs, fish, meat,
berries, fruit and mushrooms. The product is only intended
for household use. Do not use the product for other tasks.
1.3 Symbols
This product complies with applicable EU
directives and regulations.
Recycle as electrical waste.
1.4 Product overview
(Figure 1)
1. Lid
2. Trays (5)
3. Base
4. Display
5. On/Off button/Time button
6. Temperature set button
2 Safety
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.
2.1 Safety instructions for operation
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● Read and understand the instructions before
you use the product.
● Put the product on a heat resistant and level
surface during operation.
2022_001
● Do not use the product for more than 40
minutes constant. Let the product become cool
after 40 minutes of constant use. Stop the
product and pull out the power plug.
● Use the product correctly. Incorrect use can
result in personal injury and material damage.
● Stop the product and pull out the power plug
when the product is not in use. Pull the plug,
not the power cord.
● Do not let the base of the product become wet.
Do not use a wet product.
● Do not use a damaged product. Do not use the
product if the power cord is damaged.
● Let an approved service center repair the
product if it is damaged.
● Do not let nonapproved persons operate the
product unless an approved person has given
them instructions and is responsible for their
safety.
● Stay close to the product during operation.
Make sure that no children or animals go near
the product.
● Do not cover the product.
● Do not put the product near a hot stove or in a
hot oven.
● Do not let the power cord hang over the edge
of a table or a workspace.
3 Operation
3.1 To do before first operation
● Clean all parts with a damp cloth.
● Make sure that no parts are damaged.
● Make sure that the trays fit correctly in the product.
3.2 To set up the product
1
Put the product on a heat resistant and level surface.
2
Connect the power plug to a wall outlet.
3.3 To start the product
● Press the On/Off/Time button (5) to start the product.
(Figure 1)
11