VONROC AG503AC Notice Originale page 10

EN
6. Side handle connection point
7. Side handle
8. Allen key
9. Rear handle
10. Handle release knob
11. Spindle
12. Mounting flange
13. Wheel disc (not included)
14. Clamping nut
15. Spanner
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembling the protection guard (Fig. C and D)
1. Place the machine on a table with the spindle
(11) facing upwards.
2. Place the protection guard (3) over the machine
head as shown in Figure C making sure the ridg-
es on the protection guard fall into the notches
of the machine head.
3. Turn the protection guard counter clockwise as
shown in Figure D.
4. Fix the the allen screw (2) on the guard (3) with
the allen key (8).
5. You can adjust the position of the protection
guard by releasing the allen screw (2), adjust the
guard to the desired position and fixing the allen
screw again.
Never attempt to remove the guard.
Mounting and removing the wheel disc (Fig. B)
Do not use the machine without the guard.
Only use sharp and undamaged wheel discs.
• Always use suitable wheel disc for this machine
with diameter Ø 230 mm and a bore from 22.2
mm the thickness of the wheel disc should be
6 mm for wheel disc for grinding and 3 mm for
wheel disc for cutting, the mounting wheel disc
may not touch the safety guard.
Mounting
1. Place the machine on a table with the protection
guard (3) facing upwards.
10
2. Mount the flange (12) onto the spindle (11).
3. Place the wheel disc (13) onto the spindle (11).
4. Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (14) onto the
spindle (11) by using the spanner (15).
Removing
1. Place the machine on a table with the protec-
tion guard (3) facing upwards.
2. Keep the spindle lock button (1) pressed and loos-
en the clamping nut (14) using the spanner (15).
3. Remove the wheel disc (13) from the spindle (11).
4. Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (14) using the
spanner (15).
Mounting the side handle (Fig. A and E)
• The side handle (7) can be screwed into one of
the three side handle connection points (6).
4. OPERATION
Make sure that the work piece is properly
supported or fixed.
Rear handle (Fig. A)
Before rotating the handle, always switch
off the machine and remove the mains plug
from the mains.
1. To unlock the handle (9), push and hold the
handle release knob (10).
2. Rotate the handle (9) into one of the 3 available
positions and release the handle release knob
(10).
Before switching the tool on, ensure the
handle release knob (10) clicks and locks
into place when changing handle position.
Switching on and off (Fig. A)
• To switch the machine on, push the switch for-
ward and press the on/off switch (5).
• To switch the machine off, release the On/off
switch (5).
• Hold the machine away from the work piece
when turning it on and off because the wheel
disc could damage the work piece.
• Clamp the work piece firmly or use another meth-
od to ensure that it cannot move while working.
• Check the discs regularly. Worn wheel discs have
WWW.VONROC.COM