Publicité
Les langues disponibles
Les langues disponibles
the pre-existing "Wait" (L2-L6) or
"Engaged" signals (L3-L5), if any;
L1 ON confirms the P1 pushbutton
pressure.
The P2 "Wait" pushbutton enables
•
leds L2 and L6, disables the S1
acoustic signal (if it is enabled),
resets the L4 led and the pre-existing "Engaged" signals (L3-L5), if any.
The P3 "Engaged" pushbutton enables leds L3 and L5, disables the S1 acoustic signal
•
(if it is enabled), resets the L4 led and the pre-existing "Wait" signals (L2-L6), if any.
It also disables the S1 acoustic signal. Therefore, if, after enabling the "Engaged"
signal, the Pc call pushbutton is pressed only the L4 led will start flashing.
WIRING DIAGRAMS
Note: for the power supply of options shown in figures 3 and 4, as the power consump-
tion of the system is lower than 2VA, flush-mounted transformer codes 45382G, 45982G
or 45B82G can also be used (safety transformer 220/12V - 2VA).
Fig.3 - One calling point/one answering point
Data referred to a system provided with one 45RC12... + one 45RC13...
Fig. 1a
PC
L8
L5
L7
S2
L6
Publicité
