Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTION
The mains voltage must correspond with the voltage shown on the information plate in the appliance.
In the meter cupboard, the groups must each be protected with a 16 Ampere fuse at least. The connection cable must have
a core cross section of at least 2.5 mm² and a length of 1.5 m. If the cable is too short, you cannot connect the appliance and
place it against the wall before you want to insert the plug in the socket.
BUILDING - IN THE OVEN
• Check that the kitchen furniture and recess meet the set requirements in
relation to dimensions.
• Slide the oven in the kitchen furniture. Check that the base unit does not make
contact with the walls of the kitchen furniture. Make sure there is a space of
at least 2 mm between the base unit and the walls of the kitchen furniture.
Make sure the oven is in a central position between the walls of the kitchen
furniture. Caution: make sure that the connection cable does not get jammed
and does not lie on top of the appliance.
• Open the door of the appliance.
• Use the provided screws to fasten the appliance to the side walls of the kitchen
furniture.
• The opening between the cabinet and the top of the oven should not be closed.
This opening is needed for ventilation.
• Close the door of the appliance and insert the plug in the socket.
• The oven is now ready for use.
INSTALLING THE GUIDE RACKS
First install the hooks to which the guide racks will be attached later - fig. 1.
1. Identify the hooks for the rear (A) and the front (B).
2. Install the hook (C) in the top opening (D).
3. Install the hook in the bottom opening (E).
4. Push the hook down.
5. Repeat the procedure for the other hooks.
Install the guide racks - fig. 2 and 3.
Note: The procedure shows the installation for the guide rack of the right side of the appliance. The procedure for the left
side is the same, however the hook are mirrored.
1. Identify the guide racks for the left side (A) and the right side (B).
2. Carefully push the guide rack (C) in the hook (D).
3. Push the rack to the rear of the appliance.
4. Push the rack down.
5. Install the clamping bushes (E).
1
B
1
D
2
E
3
A
C
A
B
technical data
Connection voltage
Connected load
Microwave power
Ampere
Oven capacity
External dimensions without handle
Nett weight
2
1
D
2
E
3
C
230 V ~50Hz
2880W
800W
16A
72 L
596 x 595 x 546 mm (HxWxD)
45 kg
3
C
1
A
B
C
3
D
D
C
2
D
E
English
33
•
Publicité
Table des Matières
