Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS FOR AIR-POWERED IMPACT WRENCH
GENERAL SAFETY INSTRUCTIONS
SERVICE
Tool service must be performed only by qualified repair personnel.
When servicing a tool, use only identical replacement parts. Use only authorized
parts.
Use only the lubricants supplied with the tool and specified by the manufacturer.
AIR SUPPLY AND CONNECTIONS
The air supply connection must not hold pressure when air supply is disconnected.
If an incorrect fitting is used, the tool can remain charged with air after
disconnecting and thus will be able to work even after the air line is disconnected,
possibly causing injury.
Do not use any type of reactive gases, including, but not limited to, oxygen and
combustible gases, as a power source. Use filtered, lubricated, regulated
compressed air only. Use of a reactive gas instead of compressed air may cause
the tool to explode which will cause death or serious personal injury.
Use only a pressure-regulated compressed air source to limit the air pressure
supplied to the tool. The regulated pressure must not exceed 100 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 200 PSI. The
tool could explode which will cause death or serious personal injury.
Always disconnect air supply from tool:
a) before making adjustments.
b) when servicing the tool.
c) when clearing a jam.
d) when tool is not in use.
e) when moving to a different work area, as accidental actuation may occur,
causing injury.
1.
Inspect the air-powered impact wrench prior to each use in order to:
a) ensure that the proper air source is being used;
b) verify that the tool is in proper working order.
2.
Do not use a tool that is not in proper working order.
3.
Do not use oxygen or any other combustible or bottled gas to power this tool.
4.
Do not use this tool in the presence of flammable liquids or gases.
5.
Only use sockets that are specifically designed for use with this air-powered
impact wrench.
6.
Verify that the air valve (or trigger) on the air-powered impact wrench is in the "off"
position before connecting the air-powered impact wrench to the air supply.
7.
This impact wrench requires an air pressure of 90 PSI and air flow according to
the specifications that appear at the beginning of this Manual.
8.
Drain the air tank daily. Water in the air line will damage the air-powered impact
wrench.
9.
Clean the air inlet filter weekly.
10.
The pressure in the line should be increased in order to compensate for an
unusually long air hose (longer than 26' [8 m]). The diameter of the hose should
be 3/8" (10 mm) ID.
11.
Keep the hose away from heat, oil, and sharp edges. Check the hose for wear,
and verify that all connections are secure.
12.
Do not use the air-powered impact wrench for a task that it is not designed to
perform.
13.
Do not use air-powered impact wrench if it is damaged or if there is reason to
believe that it is defective.
14.
Do not use air-powered impact wrench without having been instructed in its use by
a qualified person.
15.
Do not carry the air-powered impact wrench by the air hose.
15
Publicité
Table des Matières
