Kathrein UFO 395 Caractéristiques Techniques page 15

2.2.4.3 Switching the output signal on/off
*** UFO 395-Q1
823.25MHz Standard B/G
HF Level
On
Stereo Vol + 0d B
2.2.4.4 Setting the common output level
*** UFO 395-Q1
823.25MHz Standard B/G
HF on Level
Stereo Vol + 0d B
2.2.4.5 Selecting the audio mode
*** UFO 395-Q1
823.25MHz Standard B/G
HF on Level
Vol + 0d B
Stereo
2.2.4.6 Setting the Volume
*** UFO 395-Q1
823.25MHz Standard B/G
HF on Level
Stereo Vol +
The output channel can be switched on/off via the "RF on/off" parameter.
This setting can be specifi ed individually for each output channel.
***
max
The parameter "Output Level" allows the output level of the output channel to be
continuously varied in 40 steps (approx. 20 dB).
***
The setting limits are designated "Min" and "Max".
max
This setting is applied directly on the adjacent channel also (for Q1 on Q2 and
for Q3 on Q4).
Selecting the audio mode.
The scroll buttons allow selection of the following audio modes:
***
"Auto", "Mono", "Stereo", "2-channel", "2-channel A" and "2-channel B"
max
Note:
- In "Auto" the audio mode is set by the SAT signal
- In "2-channel A" only channel 1 is transmitted during 2-channel reception
- In "2-channel B" only channel 2 is transmitted during 2-channel reception
Select the parameter "Volume".
Perform the volume setting using the scroll buttons.
***
The adjustment range is from -3 through 0 to + 3 dB.
max
d B
0
6 / 8