Publicité
Les langues disponibles
Les langues disponibles
BV 9650
WARNING: when adding warm liquids take care to prevent splashing and allow the liquid to stand for a
few minutes with lid off to permit steam to escape.
4. Plug into a 220V AC grounded wall outlet. NEVER attempt to set the jar on or remove it from the blender
base while the motor is running.
5. Set the speed control to minimum and turn on the blender. Slowly increase speed as required. The jar
may move slightly as it locates on the centering platform. Let the blender run until the desired
consistency or temperature has been reached.
6. If the contents stop circulating, DO NOT rock or shake the jar while the motor is running. Using the
PULSE function or the tamper will help. First, switch the ON/OFF button to OFF position. Then either:
a. Pulse on and off by pressing and releasing the pulse switch or;
b. Remove the filling cap and insert the tamper through the lid opening. Hold the jar handle with one
hand and with the other move the tamper to unblock the contents.
7. If it does not work, press ON/OFF switch to the off position to stop the motor. Once the blades stop
turning, remove the jar from the blender base and move the contents around with a rubber spatula.
Return the jar to the blender base, replace the lid/cap and continue blending.
8. When blending is complete move switch to the off position. WARNING: rotating can cause severe injury.
Wait until the blades have completely stopped rotating before removing or reaching into the jar.
9. Unplug from the wall outlet and remove the jar by lifting up. WARNING: the drive socket, locking nut
and blades may become very hot after extended use. DO NOT touch. Allow to cool down before
handling or cleaning.
BLENDING DRY INGREDIENTS
- Always review all the general use instruction above.
- DO NOT operate the blender continuously for more than 90 seconds when processing dry ingredients.
- When chopping nuts or other dry mixtures, ensure even chopping by adding more than enough
ingredients to cover the blades.
USE OF THE BLENDER WITH HOT LIQUIDS
- Always check the general use section when using the mixer.
- CAUTION: Be careful when filling the jug with hot liquids, it may burn with splashes.
- Leave the hot liquids for a while in the glass, letting the steam out before mixing.
- Before placing the carafe in the base, make sure that the cap is properly placed in the lid and place it in
the carafe. NEVER add ingredients while mixing hot liquids.
- Use caution when moving the jug with hot liquids.
- Place the carafe on the base, set the speed selector to the minimum and connect the mixer with the
power button. Slowly increase speed until desired. Wait until it has the necessary consistency.
- When removing the carafe from the base, open the cap or cover carefully, hot steam may escape. Be
careful the lid may be hot.
HELPFUL HINTS
- While the motor is running, ingredients can be added, with care, through the filler cap opening in the
center of the lid, except when hot liquids, they can splash and burn.
- To crush ice, place the ice cubes into the jar. Close the lid and place on the blender place. Press and
release the PULSE switch some times until the desired consistency is reached.
CARE AND CLEANING
15
Publicité
