Atlantic F17/Odyssee Meca Notice D'installation Et D'utilisation page 10

In case of mobile utilisation of the device (see applicable models
below):
- Do not use this heater near a bathtub, a shower or a pool.
- Do not use this heater in small areas when they are occupied by
people unable to leave the room by themselves unless if a constant
supervision is provided.
1.1 Where to install your heater?
- This equipment was designed to be installed in a residence. Please
ask your distributor before using it for any other purpose.
- The panel heater should be installed according to normal trade
practice and incompliance with legislation in the relevant country
(NFC 15-100 for France).
- The equipment is class 2 and is protected against splashed water
IP 24. The device can be installed in volume 2 of a bathroom (Figure
³). It's forbidden to install the device in the volume 1. The device is
to be installed so that switches and other controls cannot be touched
by a person in the bath or shower.
- Comply with the minimum clearance distances for positioning of the
panel (Figure ·).
- The wall bracket allows keeping a free space behind the device to
not disturb its regulation. The distance between the unit and the wall
should not be obstructed.
1.2 Do not install the panel heater
- In a draught that might affect adjustment (for example, under a central
mechanical ventilation unit etc...). Under a fixed power socket (Figure
») or near curtains or other combustible materials.
- In a conform position, the air outlet grid and the control unit is visible
in the upper part of the device. It is forbidden to install a vertical unit
horizontally and vice versa (Figure ¿).
1.3 How to install the panel heater?
1.3.1 Mobile device (CHG2-TAC/M)
WARNING: Devices without plug can not be used in mobile version
- The mobile installation with feet is allowed only for electronic
device with plug (CHG2-TAC/M, Figure ´ & µ). The device must
be placed on a horizontal surface. Refer to the feet instruction book
(ref 517000).
10
1. Installation