Publicité
Les langues disponibles
Les langues disponibles
8. Fit the stainless steel lance into the trigger gun and rotate
the collar until the two parts are completely locked (Fig. 9).
Fig. 9
Trigger gun
Stainless
steel lance
9. Connect the high-pressure hose to the trigger gun
(Fig. 10).
Fig. 10
High-pressure hose
10. Connect the high-pressure hose to the water outlet on the
washer (Fig. 11).
Fig. 11
(REAR)
High-pressure
hose
Collar
Trigger gun
High-pressure water outlet
m
WARNING!
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
11. Connect the garden hose adapter (female coupler) to
the water inlet of the pressure washer, then thread your
garden hose (male end) into the garden hose adapter
(Fig. 12). The garden hose must have an internal diameter
of at least 13 mm (1/2 in.) and must be reinforced. The
water supply must be at least equal to the washer delivery
capacity.
NOTE: The machine is not suitable for connection to the
potable water main.
Fig. 12
m
WARNING!
The machine is not suitable for connection
to the potable water main.
12. Attach garden hose to water supply (Fig. 13).
Fig. 13
Connect to water supply
Garden hose
m
WARNING!
The intake water temperature must not
exceed 104ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
13. Make sure the On/Off switch is set to the OFF (0) position
before plugging the unit into the power outlet (Fig. 14).
9
This end to
Garden hose
water inlet
(male end)
Garden hose
Water inlet
(female coupler)
Publicité
