SNOWJOE sunjoe SPX3000-XT1 Manuel D'utilisation page 13

m
IMPORTANT!
NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners, gasoline,
oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the
cleaning surface.
Using the Brush Attachments
This pressure washer is equipped with 2 brush attachments,
a utility brush and a heavy-duty wheel + rim brush. To
connect the brush attachments with the spray gun, follow the
instruction below.
1. Disconnect the stainless steel lance from the trigger gun
by twisting counterclockwise.
2. First connect the transfer adapter by insert it into the spray
gun and twist clockwise, as shown (Fig. 24).
Fig. 24
Trigger gun
Transfer adapter
3. Take the desired brush attachment and align the two
tabs with the inside of the transfer adapter. Once aligned,
push the brush attachment into the trigger gun, twist
counterclockwise to lock into place (Fig. 25).
NOTE: The brush attachments cannot be attached with
the spray gun without the transfer adapter.
Fig. 25
Trigger gun
Rim + wheel brush
Shutting Down
1. Turn the switch to the OFF (0) position and unplug the
power cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
6. Release the trigger and engage the gun safety lock.
m
WARNING!
Turn off the water supply and squeeze the
trigger to depressurize the unit. Failure to do so could result in
personal injury due to discharge of high-pressure water.
Taking a Break
If you are taking a break of five minutes or more between
cleaning tasks:
1. Engage the gun safety lock (Fig. 18).
2. Turn the switch to the OFF (0) position.
3. Unplug the power cord from the outlet.
Storage
m
CAUTION!
Always store your pressure washer in a
location where the temperature will not fall below 32ºF (0ºC).
The pump in this machine is susceptible to permanent damage
if it freezes. FREEZE DAMAGE IS NOT COVERED BY THE
WARRANTY.
• Store the pressure washer indoors in a dry, covered area
where it is not subject to adverse weather conditions.
• It is important to store this product in a frost-free area.
• Always empty water from all hoses, the pump, and the
foam cannon before storing.
13
Transfer adapter
Utility brush