GO/ON TBS 710 Mode D'emploi page 7

Anleitung TBS_710_SPK7:_
6. Technical data
Mains voltage 230 V~ 50 Hz
Power rating
Idle speed 0-4000 min
Tool holder 6,35 mm hex
Sound power level, L
WA
Sound pressure level, L
pA
Totally insulated
Weight
Vibration a
hv
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
7.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
7.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
04.09.2007 11:20 Uhr
8. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
710 W
and can therefore be reused or can be returned to
-1
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
96,5 dB
Defective components must be disposed of as
85,5 dB
special waste. Ask your dealer or your local council.
II / ®
2,0 kg
4,9 m/s 2
Seite 7
GB
7