PRACTIXX PX-RRM-600WI Consignes D'utilisation Et De Sécurité page 43

E11 No boundary signal
E2 Wheel motor blocked
E3 Cutter disc blocked
Obstacle sensor trigger not
E4
reset
E5 The mower was lifted
Roll-over sensor was trig-
E6
gered
Inclination sensors were
E7
triggered
E8 Docking/recharging failed
Rechargeable battery ther-
BP
mal protection
EE Error unknown
Robot mower locked (PIN
LOCK entered incorrectly too
many times)
• When the mower is in the working area, check the charging station LED
indicator. If it lights up red, make sure that the boundary wires are well
connected to the terminals on the charging station. If the problem per-
sists, check whether the boundary wires have been cut.
• Switch the mower off. Move the mower to an area that is free of obsta-
cles. Press the "START" button and then the "OK" button.
• If the error message is still displayed, switch off the product. Turn the
mower upside down and check what is preventing the wheels from turn-
ing.
• Remove the objects blocking the wheel(s), turn the mower over.
• Then press the "START" and "OK" buttons.
• Switch the mower off.
• Turn the mower upside down and check what is preventing the blades
from turning.
• Remove the objects and turn the mower over.
• Place the mower in an area with short grass.
• Then press "START" and "OK".
• Contact your specialist dealer.
• Take the mower to a specialist dealer.
• Switch the mower off.
• Move the mower to an area that is free of obstacles. Press the "START"
button and then the "OK" button.
• If the error message is still displayed, switch off the product. Turn the
mower upside down and check if there is anything preventing the front
axle from moving.
• Remove all obstacles, turn the mower up the right way again and switch
it on. Press "START" and then "OK".
• Stand the mower upright.
• Press "START" and then "OK".
• Switch the mower off.
• Move the mower to an area in your lawn with level ground.
• Switch the mower on. Press "START" and then "OK".
• Check that there is 1 metre of space before and after the charging sta-
tion, without obstacles or corners.
• The charging station must be placed on level ground.
• Manually place the mower in the charging station for charging. After the
mower is fully charged, press "START" and then "OK".
• Switch the mower off.
• Move the mower to an area in your lawn with level ground.
• Check the temperature of the rechargeable battery.
• If the temperature is too high, let the rechargeable battery cool down.
• If the temperature is too low, wait until the temperature is higher than 5°C.
• Re-start the mower.
• If the error still occurs, replace the rechargeable battery.
• If the error still occurs, contact your specialist dealer.
• Re-start the mower.
• If the error still occurs, contact your specialist dealer.
• Wait 10 minutes and then enter the PIN again
• Do not switch the robot mower off
• If the error still occurs, contact your specialist dealer.
GB | 35