Beamz SparkleWall LED96 Manuel D'instructions page 3

INSTALLATION
CAUTION:
Attention:

The installation of the fixture has to be built and constructed in a way that it can hold 10 times the weight for 1 hour
without any harming deformation.

The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This
secondary safety attachment must be constructed in a way that no part of the installation can fall down if the main
attachment fails.

Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing.

The operator has to make sure that safety-relating and machine-technical installations are approved by an expert
before taking into operation for the first time and after changes before taking into operation another time.

The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled
person once a year.

The fixture should be installed in the position where persons cannot reach and where persons may walk by or be
seated.
CAUTION:
POWERSUPPLY
On the label on the backside of the controller is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The controller must
also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that a fixture must be returned to the factory, it is important that the fixture be returned in the original
factory box and packing.
Content:
- Sparkle wall LED curtain (3x2mtr. 151.200 and 151.201 / 2x1mtr. 151.202)
- Sparkle wall LED Remote controller
- Sparkle wall LED Controller
- Power Cable
- Manual
- Reusable Zip Ties (50pcs 151.200 and 151.201 / 30 pcs 151.202)
- Carry bag
- Spare part LED's
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
INSTALLATION
The LED curtain must be installed by a professional. Never block any escape routes with the LED curtain! Connect the LED
curtains data cable with the "LED CURTAIN" socket of the controller. Attach the LED curtain to a truss.
The Sparklewall LED curtains are made of high brightness LEDs, and fire retardant cloth. The control system is designed for
friendly operation. The Sparklewall LED curtains can be produced for various ways of installation, and can be connected one to
another easily and freely.
The Sparklewall LED has a lot effects: strobe, dimming, all LED on and off , flash , sound active etc.
Please consider the respective national norms during the
installation! The installation must only be carried out by an
authorized employee or dealers!
When installing the device, make sure there is no highly in
inflammable material (decoration articles, etc.) in between a
distance of min 0.5 meter.
3