Humanscale M/Power Guide De L'utilisateur page 7

Attaching A Monitor Arm to M/Power
M2.1/M8.1 Monitor arm
Adjust Base Clamp for Correct Work Surface Depth
1
Insert Monitor Arm into the Base stem (fig. H) until you hear it
click into place.
2
Proceed to the "Attach VESA Bracket to Monitor" step in the main
M2.1 or M8.1 instruction guide.
M/Flex Monitor Arm
Adjust Base Clamp for Correct Work Surface Depth
1
Back out the two set screws installed in stem
2
Insert M/Flex post into Base and twist onto internal bolt until fully
seated
3
Tighten both set screws evenly to secure post using hex key
Installation Guidelines
This product is intended to be used with Humanscale's Monitor Arm product
line and the following office desk styles placed on a non-skid surface:
1. Systems Furniture with panel hung surfaces
2. Systems Furniture with a floor mounted panel behind the desk
3. Systems Furniture with a desk mounted panel in the rear of the desk
4. Back-to-back desks sharing the same frame
When mounting monitor arm and monitor(s) with this product on a
freestanding desk/table:
1. The freestanding desk/table should have base that is no less than 30" deep and 66.5" wide
2. The freestanding desk/table should be a minimum of 200 lbs and placed on a non-skid surface.
3. The tabletop thickness should be no less than 1.2 inches and strong enough to support a minimum
weight load of 165lb.
CAUTION: DO NOT ROTATE MONITOR PAST REAR EDGE OF DESK. DOING
SO CAN CREATE AN UNSTABLE SITUATION AND MAY CAUSE EQUIPMENT
DAMAGE OR PERSONAL INJURY.
①
H
G
②
7