Humanscale M/Power Guide De L'utilisateur page 5

Assembly Instructions
Installing M/Power Onto Edge of Table
CAUTION: Maximum weightload of M/Connect is as follows:
M2.1: 15.5 lbs. - M8.1: 28 lbs. - M10: 40 lbs. - M/Flex: 60 lbs. total
M10 is not to be used on M/Flex when mounted to M/Power
DO NOT exceed maximum weight limits.
When used in conjunction with M/Power, M/Flex Post must be limited
to 24 inches.
Place M/Power Clamp onto Table
1
Slide mount against work surface edge and
fully tighten clamp screw (fig. A)
Installing M/Power Through
A Grommet Hole or System Furniture
Disassemble Clamp
1
Remove the two screws (fig. B) using 4 mm hex key (fig. D) and
detach the smaller clamp bracket (fig. C) from the larger bracket
Place into Grommet Hole or System Furniture Gap
1
Place the L Bracket of the M/Power through
the grommet hole and to the desired position
NOTE: Minimum hole diameter is 3" (76 mm)
①
A
②
C
B
③
D
5