PNI GreenHouse WS55 Manuel Utilisateur page 4

Installing the LED floodlight
• Secure the LED floodlight to the wall with
the screws included in the package.
• The tilt angle of the LED floodlight can be
adjusted as needed.
• Connect the male plug to the female plug,
then tighten the anti-humidity nut.
Warnings
• Do not power the LED floodlight to a power source greater than 6V
• Do not power the LED floodlight to 230V AC mains
• Make sure that both the solar panel and the LED floodlight are securely fastened to
avoid accidents on windy days.
• Periodically clean the surface of the solar panel to ensure good sun exposure
• The battery can be fully charged by the solar panel from sunlight in the following
conditions: AM1.5 - 1000W / m2 - 25 ° C for at least 8 hours.
AM1.5 = airmass coefficient at sea level
1000W / m2 = intensity of sunlight radiation
25 ° C = loading temperature
In the fall, winter, or cloudy days, the intensity of the sunlight is greatly reduced and the
battery charging efficiency is also reduced, thus influencing the operating time of the LED
floodlight.
Troubleshooting
The light does not turn on
• Check that the wires are connected correctly or that they are in good condition.
• Check if the remote control has a charged battery or if it is working.
Technical specifications
Solar panel
Panel type
Dimensions
Weight
User manual
Polycrystalline
420 x 370 x 17 mm
520 g
4