Start-Up And Operation; Cleaning And Maintenance - oneConcept Clean Turbo Mode D'emploi

START-UP AND OPERATION

Before the first Use
• Take the appliance and accessories out of the box. Remove the stickers,
protective foil or plastic from the device.
• Only use the device if all the filters included the dust compartment
are placed properly, a damaged or improperly installed filter or dust
compartment may damage the unit.
Use
• Choose the desired brush: the combi nozzle for narrow surfaces or the
tube together with the floorbrush.
• Insert the plug into the power socket. Make sure that the power supply
corresponds to the required power mentioned on the rating label.
• Press the on/off button to turn on the power.

CLEANING AND MAINTENANCE

Emptying the Dust Container
• Hold the dust container above an open dustbin.
• Use the dump button to open the bottom plate of the dust container, the
dust container will open and the dirt will fall out.
Cleaning the Filter
• Take out the dust container by pushing the dust container release button.
• Turn the lid of the dust container anticlockwise and remove it.
• Carefully remove the cyclone filter from the dust container.
• Remove the foam filter holder from the cyclone filter.
• Remove the foam filter from the filter holder. Please note: the thin fabric
filter is firmly attached to the filter holder and cannot be taken out of the
holder!
• Thoroughly rinse all the parts with clear, lukewarm water. Do not use any
cleaning agent.
• Shake off any excess water and allow all the parts to dry completely
before reinserting them.
EN
13