Troubleshooting - oneConcept Clean Master Mode D'emploi

TROUBLESHOOTING

Note: If your device no longer functions properly, exhibits damages or
requires a spare part, please contact the customer service. For your own
safety, do not perform any repairs yourself.
The following table gives you tips on how to resolve minor problems yourself.
Problems Potential causes
Is the auxiliary air valve on
the handle open?
Is the dust bin too full?
Are the filters very dirty?
The suction
power is weak.
Is the nozzle, telescoping tube
or suction hose plugged?
Is the mains plug not correctly
connected with the socket?
Is the socket defective?
The vacuum
Has the fuse blown or is it
cleaner has no
defective?
suction power.
Are the filters plugged?
The device emits Has the dust bin not been
dust when closed properly and/or is it
vacuuming. not (properly) inserted in the
device?
The power cord The cord has not been
cannot be wound properly wound up in the
up completely. device.
An unpleasant Are you using the device for
odour develops the first time?
when vacuuming.
Solutions/tips
Close it.
Empty the bin.
Clean the filters.
Turn the device off,
pull the mains plug
out of the socket
and remove the
obstruction.
Correct the position of
the mains plug.
Try another socket.
Check the fuse
for your mains
connection.
Clean the dust and
exhaust filter.
Correct this.
Pull it out somewhat
and then push the
button for engaging
the cord winder again.
An odour often
develops when using
new devices for the
first time. The odour
should disappear once
you have used the
device a few times.
EN
17