BEHA PB Manuel page 52

TECHNICAL INFORMATION
Ÿ If you hold the button for 10 sec. the heater will go back to factory setting, i.e. the stored
programme will be deleted and the heater will start calibrating for a new temperature profile.
The setting of the thermostat wheel will prevail.
Ÿ Tap on the Connecting (1) button and the white light will be on for 10 sec. if it initially was
dimmed down. This is useful if the room is bright.
When connecting the heater keep your finger on the button for 3 sec. until the blue light
Ÿ
blinks.
When a heater is selected in the app and the phone is within the range of the heater the blue
Ÿ
light on the heater will switch on. TEMPERATURE or PROGRAMME can be changed.
The blue light will blink three times when re-setting the heater.
Ÿ
The white light on the heater is on when the heater is controlled from the app.
Ÿ
When the heater is controlled from the app any command from the app will make the white
Ÿ
24/7
light on the heater be on for 10 sec. Then the light intensity will be reduced.
The white light will blink three times when re-setting the heater.
Ÿ
THE HEATER CAN BE USED MANUALLY AND WITHOUT APP PROGRAMMING
Ÿ
The selected programme in the app will be sent to the heater when pressing STORE CHANGES. The
Ÿ
programme will be stored in the heater electronics.
Ÿ When changing phone heaters must be linked up again.
Ÿ When connecting a heater to the app the phone must be within reach of the heater.
Ÿ Re-setting of the heater to factory setting, only when the heater is transferred to a new owner.
Ÿ The thermostat can be set at minimum 5°C.
Ÿ The red light in the thermostat wheel is on when the heater is heating.
Ÿ The App will be automatically updated provided the phone is set at automatic updating and the phone is
connected to a router.
If the phone is outside of the range of the heater, the heater cannot be controlled from the app but it will
Ÿ
follow the app programme.
Ÿ In the opening page of the app the Bluetooth signal strength is indicated for each connected heater.
Ÿ Heaters within the Bluetooth range are shown in black letter, the ones outside in grey.
Ÿ Heaters can be connected to multiple users.
Ÿ BEHA Heaters with steel front have protection class IP24 and can be installed in bathrooms and laundry
rooms I accordance with local norms.
By power outage:
Without app:
The heater returns to set temperature.
With app: The heater will go to the programme and setting it had when the power outage happened. To get back
to present time, each heater has to be opened in the app. Then tap on SAVE CHANGE. The heater will receive
correct time setting from the app.
Cold draft/Open window function:
When opening a window and the temperature drops more than 5°C within 40 sec the cold draft function is
activated. The heater changes between set temperature for 10 seconds, and 5°C for 30 seconds. The function is
active for max. 15 minutes.
52
GB