Publicité
Les langues disponibles
Les langues disponibles
To program the HT 300 RF to switch off GreenPower outlets on the HTS 1900G, you must program the HT 300RF
to recognize when your HDTV is in sleep or stand-by mode .
Programming Instructions
1 .
Plug the HT 300RF into the AC wall outlet nearest to your HDTV .
2 .
Plug your HDTV into the outlet labeled "GREENPOWER RF CONTROL . "
3 .
The GreenPower On/Off switch is located the bottom of the HT300RF . Make sure the switch
is set in the On position for programming .
4 .
With the HDTV off and in stand-by mode, press and hold "Program" button for 5 seconds and release
when it beeps twice .
5 .
Hold "Program" button for 5 seconds to learn the stand-by current draw of the HDTV .
THE HT 300RF will beep TWICE when it has learned .
(Hold "Program" button for 10 seconds to reset to factory default values, unit will beep 5 Times .)
20
PRoGRaMMInG THe HT 300 Rf To
ConTRol MonsTeR GReenPoWeR
oUTleTs
™
Publicité
