Télécharger Imprimer la page

AUTO-HAK P30A Guide Rapide page 4

Publicité

Les langues disponibles

Les langues disponibles

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
12
11
4
10
6
10
10
9
This towbar is designed to assembly in following cars:
CITROEN C5 I Break, ESTATE, produced since 10.2004 till 03.2008,
catalogue no. P30A and is prepared to tow trailers max total weight
1600 kg and max vertical load 85 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and correct
exploitation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
5
10
1
7
22
3
The instruction of the assembly
1. Underneath of the bumper unfix plastic spoiler (not used any
more).
9
2. In original prepared points fix loosely side brackets (pos. 4
and 5) using bolts M10x40mm (pos. 10).
10
3. Slip main bar of the towbar (pos. 1) between side brackets and
fix it by bolts M12x45mm (pos. 9). Remember about angle
elements (pos. 6 and 7).
4. To handles pos. 25 fix the bumper by bolts M8x25mm (pos.
12).
5. Fix body of the automat according to supplied instruction.
6. Fix the socket plate (pos. 3) as shown on the drawing.
7. Tighten all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station)
9. Complete paint layer damaged during installation.
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm

Publicité

loading