Paradigm Reference MILLENIA TRIO Serie Mode D'emploi page 4

BRACKET INSTALLATION (Figs. 4a – 4e)
IMPORTANT: Please read before installing bracket
Paradigm DOES NOT supply hardware for mounting bracket to the wall. Mounting hardware shown is
an example only; hardware will vary depending on wall type.
Install into 1/2˝ (13 mm) or 5/8˝ (16 mm) drywall only. Screws must be long enough to go through anchor
bolts and firmly into drywall (see inset circle, below) .
• 1 – Wall-mounting bracket (with 2 protruding screw heads) • 2 – Sets of 2 self-adhesive bumper pads (marked for 0° or 7° tilt)
• 4 – Anchor bolts (minimum load rate 25 lb / 11.3 kg) • 4 – Flathead (Countersunk) screws
Fig. 4a
Position bracket and ensure it is level. Mark the two inner screw holes. Drill
pilot holes, then press anchor bolts firmly into drywall and screw in. Follow
with flathead screws: DO NOT SCREW ALL THE WAY IN AT THIS POINT
—leave screw heads protruding slightly.
Fig. 4c
Remove the two flathead screws (not shown) . Drill outer pilot holes, then press
anchor bolts firmly into drywall and screw in. Now insert all four flathead
screws and tighten.
4
BRACKET PARTS LIST:
PARTS REQUIRED, NOT INCLUDED:
NOTE: This step is for positioning
only. Screws will be removed in
next step to allow installation of
additional anchor bolts
WARNING! For stability, all four
flathead screws MUST be used
Fig. 4b
Bracket is slotted (see illustration) , to allow further adjustment up or down,
if necessary. Re-check to ensure bracket is level. Mark outer screw holes.
WARNING! All screws must be inserted
straight and fully tightened to ensure
correct operation of anchor bolts.