REED PLAS1 Guide D'utilisateur page 4

SHARPENING
Dull cut-off tools, if not chipped
or broken, can be sharpened by
any machine shop that has silicon
carbide or diamond wheels. Ordi-
nary grinding wheels will not effec-
tively grind carbide. The bevel tool,
made of hardened tool steel, can be
sharpened with conventional grinding
equipment.
LUBRICATION
No lubrication is needed and the cutter parts should not be oiled. Dry graphite
occasionally applied to the moving parts will assure long life and easy operation.
SAFETY PROCEDURES
• OPERATE TOOL UNDER OSHA AND OTHER APPLICABLE SAFETY STANDARDS.
Figure 4
NOMINAL PIPE CUTTER SIZE
6"
8"
10"
12"
14"
15"
16"
18"
20"
22"
24"
27"
28"
For beveling over 12" diameter plastic pipe, the "D" unit, which has the bevel tool-holder at a different angle from the
"A" unit, must be used. The "A" unit can be used as a substitute for the "C" unit on larger than 12" diameter pipe.
4
mm PIVOT LINK SECTIONS
160 A & C
200 A & C
250 A, B & C
315 A, B & C
355 D* & 2 - C's
380 D & 2 - C's
400 D & 2 - C's
450 D, B & 2 - C's
500 D & 3 - C's
560 D & 3 - C's
600 D, B & 3 - C's
700 D & 4 - C's
800 D & 4 - C's
HOLES
Inner holes
Outer holes
Inner holes
Outer holes
1 inner, 1 outer
Outer holes
Outer holes
1 inner, 2 outer
2 inner, 1 outer
Outer holes
3 inner, 1 outer
2 inner, 2 outer
Outer holes