Publicité
Installation Notes
•
Add threadlocker (not included) to all screws before installing.
•
•
Installation - Mechanical & Electrical
1.
2.
3. Mount backcase on the wall with provided screws. Make sure to pull keypad cable through the center hole (marked C, below).
Keep keypad perpendicular to the floor.
4.
4. Connect the wires based on the following wiring diagram.
5. Mount keypad to the backcase by using the provided case screw.
1 Red (power +)
2 Black (power ground)
3 Brown (door magnet)
4 Orange (zone 1 remote release)
5 Yellow (zone 2 remote release)
6 Green (remote release - COM)
7 White (NO)
8 Pink (C)
9 Aqua (
NC)
10 Blue (
NO)
11 Purple (
C)
12 Gray (NC)
13 Brown/White (door bell)
14 Black/White (door bell)
Shielding line
Keypad Programming
PROGRAMMING NOTES:
If any incorrect key combinations are entered, a continuous beep will be heard. Start over and try again.
If 3 invalid consecutive keyboard input entries occur, the keypad will be disabled for 60 seconds.
}
Input DC: 12V to 24V
Input AC: 12V to 24V
Zone 1
UNLOCK
(dry)*
Zone 2
UNLOCK
(dry)*
+
8
-
0.5W recommended
Shield ground
*NOTE: Flyback diode(s) may be necessary when
driving external relays, electric strikes or magnetic
locking device coils without internal protection.
C
Zone 1
or
NO or NC
Zone 2
DIODE
B
B
A
C
Backcase
A
B
B
Locking Device
Power +V
Locking
Device
Coil
Locking Device
Power - RTN
Publicité
