Gewiss Chorus GW 10 741 Mode D'emploi page 24

1. Power the device via the bus.
2. Follow one of these procedures for the system to acquire the device:
• Automatic acquisition:
- select the "Find/Configure" or "Scan" command on the "System" menu;
• Manual acquisition (factory default settings have been changed):
- select the "Add device" menu from the "System" menu;
- press the programming key briefly (< 2 seconds). The programming LED
turns on during the acquisition process (figure A).
The device acquired is listed with a number assigned to it, a product code and
a list of the channels in the "Devices" view.
3Insert the device in a Chorus 3-module support, making sure the temperature probe
is on the left.
Finish installation (figure H) with a KNX Chorus touch plate.
INSTALLATION
Initialisation with Easy Controller
Completion
24