Publicité
Les langues disponibles
Les langues disponibles
•
the trailer should be as clean and dry as possible.
The wheels of the trailer must be immobilized (parking brake applied) and
•
stabilizer bars placed on the corners of the trailer.
•
Make sure all windows are closed, internal heaters and refrigerators are
turned off, and there are no loose and/or protruding objects such as
antennas on the surface of the trailer.
Be aware of any protruding and/or sharp edges, especially metal edges,
•
that could potentially damage the cover.
At least 2 people are required to put the cover on and the use of a ladder or
platform os recommended.
The cover should be pulled over the trailer starting from the front of the trailer,
i.e. the side with the hitch to the vehicle.
To make the process easier you can unzip the zippers at the ends of the cover.
After pulling the cover over the entire trailer, pull the straps located on one of
the side walls of the cover underneath the trailer.
Attach their prongs to the corresponding slots on the other, parallel side of the
cover. Tighten the straps so that the cover fits snugly against the side walls of the
trailer, but do not overtighten to prevent damage to the cover itself.
Assemble the cover in the reverse order of putting it on.
IMPORTANT: Before folding the unused cover into a bag, make sure it is free of
debris and most importantly dry.
Store in a dry area away from direct heat sources.
3.3.
Cleaning and maintenance
a)
To clean the surface, use a soft brush or warm water with a soft sponge.
b)
Dry the product well after each cleaning with water before reusing it or storing
it.
c)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning, as these may damage the surface of the material which the product
is made of.
d)
Do not wash or dry clean!
Publicité
