This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the
permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53.
Substance Reduction
NSF Reduction
Aesthetic Effects
Requirements
≥50%
Chlorine Taste/Odor
≥85%
*
Particulate Class II
Contaminant
NSF Reduction
Reduction
Requirements
Lead: @ pH 6.5
0.01 mg/L
Lead: @ pH 8.5
0.01 mg/L
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 63°F (17.2°C).
It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
Model WF-NL240: Change cartridge at least every 6 months.
Use replacement cartridge NL240, part #4396508.
2010 suggested retail price of $32.99 U.S.A./$44.95 Canada.
Prices are subject to change without notice.
Model WF-L400: The filter monitor system measures the
amount of water that passes through the filter and alerts you
to replace the filter. When 90% of the filter's rated life is used,
the filter indicator light changes from green to yellow. When
100% of the filter's rated life is used, the filter indicator light
changes from yellow to red, and it is recommended that you
replace the filter. Use replacement cartridge L400, part
#4396508. 2010 suggested retail price of $32.99 U.S.A./
$44.95 Canada. Prices are subject to change without notice.
The product is for cold water use only.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
*
Class II particle size: >1 to <5
**
Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.
These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
***
® NSF is a registered trademark of NSF International.
PERFORMANCE DATA SHEET
Base Grille Water Filtration System
Model WF-NL240/NL240 Capacity 240 Gallons (908 Liters)
Model WF-L400/L400 Capacity 400 Gallons (1514 Liters)
System tested and certified by NSF International against
NSF/ANSI Standard 42 for the reduction of Chlorine Taste
and Odor, Particulate Class II*; and against NSF/ANSI
Standard 53 for the reduction of Lead.
Average
Influent Challenge
Influent
Concentration
1.9 mg/L
2.0 mg/L ± 10%
833,333/mL
At least 10,000
particles/mL
Average
Influent Challenge
Influent
Concentration
0.15 mg/L***
0.15 mg/L ± 10%
0.15 mg/L***
0.15 mg/L ± 10%
Maximum
Average
Effluent
Effluent
0.05 mg/L
0.05 mg/L
100,000/mL**
40,667/mL
Maximum
Average
Effluent
Effluent
0.001 mg/L
0.001 mg/L
0.003 mg/L
0.001 mg/L
Note that while the testing was performed under standard
laboratory conditions, actual performance may vary.
Refer to the front cover or "Assistance or Service" section for
the Manufacturer's name, address and telephone number.
Refer to the "Warranty" section for the Manufacturer's limited
warranty.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
Minimum %
Average %
Reduction
Reduction
97.4%
97.4%
88.0%
95.1%
Minimum %
Average %
Reduction
Reduction
99.3%
99.3%
97.9%
99.0%
City or Well
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8°C)
0.5 gpm (1.9 Lpm) @ 60 psi.
11