Craftsman ELLINGTON Penbrooke PNB52AO5 Guide D'installation page 9

10. Light Kit Assembly (Optional). (cont.)
If you wish to use your fan WITH the light kit,
connect male plug from switch housing to
female plug from light kit fitter. Make sure plugs
connect tightly.
Carefully arrange wiring in fitter plate and align
holes in switch housing with holes in fitter
plate. Re-insert screws that were previously
removed. Tighten all 3 screws with a Phillips
screwdriver.
Install 2 medium base compact fluorescent
13-watt bulbs (included).
Important: When replacing bulbs, please allow
bulbs and glass shade to cool down before
touching.
Remove finial, finial plate and threaded washer
from threaded rod on light kit fitter.
Raise glass shade in order to guide pull chains
through corresponding holes. Align threaded
rod on light kit fitter with hole in middle of
glass shade and push up gently, allowing
threaded rod to come through hole. (Be sure
pull chain for fan operation does not rub against
bulb during operation.) Secure glass shade with
threaded washer. Do NOT overtighten threaded
washer as glass may crack or break.
Align hole in center of finial plate with threaded
rod, allowing pull chains to come through
appropriate holes in finial plate, and push up.
Thread center pull chain through hole in finial
and re-attach finial. Do NOT overtighten finial as
glass may crack or break.
male plug
female plug
reverse
switch
bulb
Hg
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
page 8
motor housing
fitter plate
switch housing
light kit fitter
threaded rod
glass
shade
threaded washer
finial plate
finial
LAMP CONTAINS MERCURY