PNI L3000W Manuel Utilisateur page 7

The correct connection of the inverter is shown in the following diagram.
Caution
1. Do not use the AC output of the inverter to connect it to the 230V mains,
so as not to burn the inverter.
2. Connect the loads one by one and do not exceed the declared maximum
power of the inverter.
3. For inductive loads choose an inverter with a maximum power 2-3 times
higher.
4. It is recommended to start the car only with the inverter turned off, because
this procedure will consume a lot of current and can affect the inverter.
5. The inverter must be mounted in a ventilated place, must not be covered
and must be protected from access by people.
6. Do not connect the inverter to discharged, defective or old batteries, as
this may cause the inverter to burn out.
7 User manual