Ghost Batly Manuel page 18

CCXX - Selection of JUMP mode (the colors are linked one after the other)
Press the MENU key until CCXX is displayed. Press ENTER.
The display shows "CC01" to "CC99". Select the desired speed with the UP & DOWN keys. Press ENTER to
validate the selection.
"CC01" (slowest) and "CC99" (fastest).
EEXX - Selection of Pulse mode
Press the MENU key until EEXX is displayed. Press ENTER.
The display shows "EE01" to "EE99". Select the desired speed with the UP & DOWN keys. Press ENTER to
validate the selection.
"EE01" (slowest) and "EE99" (fastest).
FFXX - Selection of Fade mode (the colors follow each other when fading)
Press the MENU button until FFXX is displayed. Press ENTER.
The display shows "FF01" until "FF99". Select the desired speed with the UP & DOWN keys. Press ENTER to
validate the selection.
"FF01" (slowest) and "FF99" (fastest).
StXX - Strobe mode selection
Press the MENU key until StXX is displayed. Press ENTER.
The display will show "St01" to "ST15". Select the color of the Strobe with the UP & DOWN keys. Press EN-
TER to validate the selection. The display indicates SP01 to SP99. Select the desired speed with the
UP & DOWN keys. Press ENTER to validate the selection.
"SP01" (slowest) and "SP99" (fastest).
Manu - Manual Mode
Press the MENU key until MANU is displayed. Press ENTER.
Color-by-color intensity adjustment: R = Red - G = Green - B = Blue - W = White.
Press the MENU key until RXXX (or GXXX - BXXX - WXXX) is displayed.
Press ENTER. Select the color intensity with the UP & DOWN keys. Press ENTER to validate the value.
Note: During an extinction / re-ignition cycle the projector retains its last state.
Ircl - Activation of the IR remote control
Press the MENU button until IRCL is displayed. Press ENTER.
The display shows "ON" or "OFF".
Select ON, with the UP & DOWN keys. Press ENTER to validate, the projector will react to the information
transmitted via the IR remote control.
Select OFF with the UP & DOWN keys. Press ENTER to validate, to deactivate the remote control.
LED - Adjustment of the display backlighting
Press the MENU button until LED is displayed. Press ENTER.
The display shows "ON" or "OFF".
Select ON, with the UP & DOWN keys. Press ENTER to validate, the display remains on constantly.
Select OFF with the UP & DOWN keys. Press ENTER to validate, the display goes off after 30 seconds.
Page 18