Vonyx VMM-K Serie Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the product be irreparably damaged. The product must also be
directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROL ELEMENTS
1. Microphone/Line Input
Balanced XLR and 6.3mm (1/4") input jacks for connecting microphone, musical instrument or
audio device.
2. +48V Phantom
This switch toggles phantom power on and off. When the switch is on the mixer supplies +48V
phantom power to all channels that have XLR input jacks. Turn this switch on when using one or
more phantom-powered condenser microphones.
3. PAD button
Press this button to attenuate the input signal by 26dB.
4. Gain Controller
Adjusts the input signal level. To get the best balance between the S/N ratio and the dynamic
range, adjust the gain so that the peak indicator (9) lights only occasionally and briefly on the
highest input transients. The +20dB to +64dB scale is the MIC input adjustment range. The -6dB to
+38db scale is the line input adjustment range.
5. Treble controller
Adjust the high tone control.
6. Mid controller
Adjust the mid tone control.
7. Bass controller
Adjust the low tone control.
8. FX Controller
Adjust the effects volume for corresponding channel.
9. Peak LED indicator
The peak-led lights up when the input signal is driven too high. If this happens, back off the gain control and, if
necessary, check the setting of the channel EQ.
10. Level control
Adjust to balance the volume of each channel.
11. Program controller
Select from 16 kinds of internal digital effects.
12. Repeat
Adjust the frequency of echo repeat.
13. FX Level
The aux send jacks carries the master aux mix (from the channel FX controls).
14. VU-Meter
Level indicators can show the signal level from output. Adjust the level controller to
lower the level if peak indicator light up in red.
15. Phones Level
Adjust the volume of headphone.
16. Send controller
Adjust the volume level of the Aux signal provided at connector (21).
17. Return controller
Adjust the return level.
18. Master Fader
Adjust the output volume of the main mix.
4