Transmission Losses; Problems Inside The Usb-Receiver - AREX TL-300 Mode D'emploi

1. Transmission losses

Sometimes transmission losses may arise, indicated by missing
temperature data in the sensor's curve display.
Data losses may be caused by:
1.

Problems inside the USB-receiver

2. Problems in the temperature sensor module
3. Problems in the signal transfer between temperature sensor
module and USB-receiver
1.1. Problems inside the USB-receiver
The receiver does not registrate a single data signal, even if the sensor
is located at a minimum distance to the receiver.
Potential problems:
- USB-cable between receiver and computer is missing or defect
- Improper installation of the USB-module
- Unknown software problem in the computer system
Suggested solutions:
- Check the display window in the temperature logger display
for a field in the lower left area. The field is to display the value
'ready' continously. If the display intermittently displays
'RF_USB-Communication failure', the Windows operating
system failed to find the USB-module.
- Remove the USB-cable, wait about ten seconds and reconnect
the cable.
- Deinstall the temperature logger application software and
reinstall it again.

E
N
G
L
I
S
H