Assembly/Electrical Installation - infra world Saunacontrol T3 Notice De Montage Et D'utilisation

4.3b. Mounting the retractable operating unit to the inner wall:
I. Make a recess (W x H: 100 x 110 mm) at approx. 1550 mm height (upper edge of operating unit)
at the desired position on the inner wall of your cabin (Fig. 4).
Attention: When assembling the operating unit, keep a minimum distance of 1000 mm from the
II. Put the operating unit into the plastic frame supplied (Fig. 5).
III. By using a pulling aid, lead the black connecting cable of the operating unit through the cable duct of
the sauna onto the roof (Fig. 8).
IV. Fix the operating unit into the recess on the sauna wall by means of the metal clamps on the back (Fig. 6).
Fig. 7
4.4. Assembly of the infrared radiator controls
Drill a hole with a diameter of 60 mm. The controls for dimming the infrared radiator can be installed
directly next to the radiator in the sauna according to demand. In total, 2 controls can be connected to
the power unit (see Fig. 9).
4.5. Electrical installation:
Connect the controls according to the following instructions for electrical installation (Fig. 10).
EN
Fig. 10
24
sauna heater (Fig. 7).
Fig. 8 Fig. 9