Publicité
Les langues disponibles
Les langues disponibles
! when 2 levels of the battery
indicator start flashing after
pressing button E 7 c, the
battery is not within the
allowable operating temperature
range
• Battery protection
The tool is suddenly being switched
off or prevented from being switched
on, when
- the load is too high --> remove
load and restart
- the battery temperature is not
within the allowable operating
temperature range of -20 to
+50°C --> 2 levels of the battery
level indicator start flashing when
pressing button E 7 c; wait until
battery has returned within the
allowable operating temperature
range
- the battery is nearly empty (to
protect against deep discharge)
--> a low battery level or flashing low
battery level 7 b is shown by the
battery level indicator when pressing
button E; charge battery
! do not continue to press the
on/off switch after the tool is
switched off automatically;
battery may be damaged
• On/off 2
- press and hold button A for 1
second to turn on the speaker
- indicator C will start flashing
- press and hold button A for 3
seconds to turn off the speaker
! after approx. 45 minutes of
inactivity the speaker will
automatically turn off
• Volume
- use buttons D to increase or
decrease the volume
• Connecting with Bluetooth
- turn on the speaker and it will
automatically enter into Bluetooth
pairing mode
- indicator C will start flashing
- the speaker will automatically try
to connect to the last device it was
paired to
- if no connection can be made,
the speaker will be available for
connection to other Bluetooth
devices for approx. 45 minutes
! after approx. 45 minutes of
inactivity the speaker will
automatically turn off
- when a connection is made, the
indicator will turn blue continuously
- to pair to a different device press
and hold the Bluetooth pairing
button B for 3 seconds
- indicator C will start flashing
! read the instructions provided
with your device
• Connecting with AUX 2
- open dust cover H
- plug in audio cable in the AUX port
G and connect to a MP3 player, CD
player or other audio device
- indicator C will turn blue
! without a connection the speaker
will automatically enter into
Bluetooth pairing mode
• Charging an external USB device 2
- open dust cover H
- connect a USB device with USB
charging cable to port F
! any device that uses more than
the maximum output current (see
technical data) will trip a self-
resetting overload protection and
disable the speaker, reactivate
by removing the USB device and
turn on the speaker
! when not in use, remove the
charger cable(s) and battery
MAINTENANCE / SERVICE
• This tool is not intended for
professional use
• Clean the tool with a dry, soft cloth (do
not use cleaning agents or solvents)
! remove battery from tool before
cleaning
• If the tool should fail despite the care
taken in manufacturing and testing
procedures, repair should be carried
out by an after-sales service centre for
SKIL power tools
- send the tool undismantled
together with proof of purchase to
your dealer or the nearest SKIL
service station (addresses as well
as the service diagram of the tool
are listed on www.skil.com)
• Be aware that damage due to overload
or improper handling of the tool will
10
Publicité
