Forch Super Silent Mode D'emploi page 23

Protection against ergonomic hazard
■
Adjust body position to work.
■
Never use pneumatic tools in an exhausted state or under influence of prescription
drugs, drugs or alcohol.
Protection against hazards from slipping, tripping and falling
■
Slipping/tripping/falling are a cause of serious injury.
■ Always pay attention to the corresponding industrial safety regulations.
■
Adress to your employer in case of questions..
■
Be aware of possible risks before starting your work.
Protection against risks associated with the operational environment of the
pneumatic tool
■ Pay attention to not immediately recognizable hazards at the workplace.
■
Do not damage power cables, tubes or hoses.
■
Be aware of all possible dangers which can caused by your work.
■ Make sure that the pneumatic tool, the accessories and the work piece are well held or
fixed.
■
Keep your workplace clean and in good order and make sure to provide good ventilation
and illumination.
Protection against risks arising from unexpected actuation or response
time
■ Do not carry the pneumatic tool on the trigger.
■
Always place device safely.
■
To provide jamming of the trigger due to dirt or dust the device has to be protected from
coarse dirt.
■
For use only by trained personnel.
Protection against risks arising from (temporary) failure and/or wrong
positioning of protective measures/means
■
Gloves should not interfere into operating the device.
■
Do not remove plates or safety stickers.
■ Non-respect of the warnings may result in injuries.
■
Compressed air supply hose needs to have an accessible shut-off valve.
Protection against other hazards
■
Pneumatic tools and accessories are not to be modified.
■
Only use for the purpose recommended in the operation manual.
■ Only use accessories recommended by manufacturer.
■
It is the responsibility of the user to make this safety information accessible to other
■
users of this device.
■
Do not pull, carry or throw this pneumatic device at the hose.