CAPTELEC BLUE PRESSURE Manuel D'instructions page 27

T 1003 / XY-B03
C. HOW TO USE IT
1) Insert or replace batteries
1. Push the battery cover located on the bottom side on the unit as
shown in the figure.
2. Remove old batteries and insert new ones. Use LR6 or AA alkaline
batteries and use batteries of the same type only.
3. Make sure the battery polarities (+) and (-) match the making on the
battery compartment.
4. Place back the battery door.
NOTE:
• Insert the batteries as shown in the battery compartment. If not, the device will not work or even be damaged.
• When battery power becomes weak, the [ ] icon and "E6" appear in the display, replace all batteries with new ones. Do not
mix old and new batteries.
• Never use rechargeable batteries. This may damage the unit.
• Battery life may vary with ambient temperature and may be shorter at low temperature.
2) TO SET DATE AND TIME
After inserting batteries or press SET button in off mode to enter clock mode
1. "Year" will blink on display automatically
2. Press MEM button to select year
3. Press SET button to confirm and "Month" will blink
4. Press MEM button to select month
5. Press SET button to confirm and "Day" will blink
6. Press MEM button to select day
7. Press SET button to confirm and "Hour" will blink
8. Press MEM button to adjust to desired hour
9. Press SET button to confirm and "Minute" will blink
10. Press MEM button to adjust to desired minute
11. Press SET button to confirm and measurement units will blink.
Keep 0 if you want to choose mmHg or switch to 0.0 with MEM button if you
want to select KPa.
We advise you to keep mmHg as it is more convenient to read the results. KPa is
for international measures.
Press ON/OFF button to confirm setting and back to sleeping mode.