Inventum IOC6070GK Mode D'emploi page 21

INSTALLATION DIMENSIONS
In the drawing below, all the dimensions are displayed in mm.
ELECTRICAL CONNECTION
Check that the voltage in your home corresponds with the voltage printed
on the appliance.
These groups in the meter must be secured with at least 16 amps each.
The connection cable must have a cross-section of at least 2.5mm² and
must have a length of at least 1.5 m. When the cable is too short, you have
no room to already connect the oven and place it against the wall before
plugging it in.
THE FITTING OF THE APPLIANCE
• Check that the cabinet and the space for the oven meet the dimension and
ventilation requirements.
• Slide the oven into the cabinet. Make sure the housing of the oven does not
come in contact with the walls of the kitchen cabinet. Make sure there is at
least 2 mm between the oven casing and the walls of the kitchen cabinet.
Make sure the oven is centered between the walls of the kitchen cabinet.
Note: Make sure the cable is not stuck and does not lie on top of the oven.
• Open the oven door.
• Use the provided screws to fasten the oven to the cabinet. Take care not to
over tighten and break the spacer.
• Close the oven door and plug the appliance in.
• The oven is now ready for use.
N
L
21
English •