Airone PARSIFAL INOX 90 Instructions Pour L'utilisation Et L'entretien page 14

REMOTO CONTROL
If the button is pressed when the suction motor is on, the motor automatically turns off.
WARNING:
with the hood extracted 20cm, the suction motor runs at 3 speeds (no intensive), while with the hood extracted
50cm, the suction motor runs at 4 speeds.
NOTES:
The hoods with the standard remote control are already configured.
For optional and/or replacement remote controls it is necessary to start the learning process.
When the hood is powered up, the electronics will remain in learning mode for 5 seconds, within which any key on the
remote control must be pressed.
If the remote control breaks, it is possible to switch off the motor and close the hood by turning the power supply to
the electronics off and on 4 times in succession, at intervals of no more than 20 seconds.
CONTROL FUNCTIONS
BUTTON "A"
With suction motor turned on, every time the button is pressed the motor
speed will be reduced of one step.
BUTTON "B"
With the downdraft extracted from 20 to 50 cm, the suction motor can be
turned on and/or off.
Hood with LED lighting: With the downdraft extracted, each press of the button,
in sequence: turns on the motor at the second speed, turns on the lights, turns
off the motor, turns off the lights.
BUTTON "C"
With suction motor turned on, every time the button is pressed the motor
speed will be increased of one step. At the 4th motor speed (intense) after 5
minutes the 2nd speed is automatically set.
BUTTON "D"
By pressing the button once, the downdraft is of 20cm extracted.
By pressing the button one more time the downdraft is completely extracted.
If the button is pressed while the downdraft is moving, the downdraft automati-
cally stops.
To restart the movement, it is necessary to press button "D" or "E".
BUTTON "E"
By pressing the button once, the downdraft returns in completely.
If the button is pressed while the downdraft is moving, the downdraft automati-
cally stops. To restart the movement, it is necessary to press button "D" or "E".
EN -12