Eurotops 48662 Mode D'emploi page 7

G 5034 /
TMX-5034
Warning: Please read this instruction manual carefully before using the instrument and keep it for future use.
A. SAFETY INSTRUCTIONS
1. The device is intended exclusively for private and not for commercial use. Only use this device as describe in this
instruction manual.
2. Do not leave the device unattended when plugged in.
3. Do not use the appliance if it is damaged, malfunctions, has been dropped into water, or has been dropped.
4. Never attempt to repair the device by yourself. Always have it repaired by a qualified service center or repair center.
5. Keep it away from heat sources such as radiators, to avoid deformation of plastic parts.
6. Wear safety glasses and, when performing work that generates dust, use a filter mask.
7. Do not use coarse or abrasive sponges/cloths or steel wool to clean the appliance.
8. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capacities, or by persons lacking in experience or knowledge, unless they are supervised or instructed on the use of
this apparatus by a person responsible for their safety.Children should be supervised to ensure they do not play with
this appliance.
B. HOW TO USE IT
1) Insert or replace batteries
- Remove the battery cover on the back of the unit.
- Insert 2 AAA batteries observing the correct polarity indicated.
- Replace the cover.
2) How to change the bits
1. How to loosen bit
Pull out the bit holder from the tool. You hear some sound. That means the bit already
loosened, and you can move away the bit.
2. How to change bit
Push the new bit into the bit holder hole to suitable depth.
! Note: Meanwhile, you always need to use finger to hold the bit holder to avoid it be
pushed down by new bit. Otherwise, the new bit can not be pushed into bit holder.
Once the new bit push into the bit holder, then press down the bit holder to fix new bit.
3) Operating
This tool is be designed to safety working mode. Means you always need to press the ON/OFF
switch button, then the tool will be kept on operating.
ELECTRICAL ENGRAVER SET EN