Tritech T11 Mode D'emploi page 44

26. Reinstall crankshaft cover plate #55 with 4 screws #40. See diagram "B".
27. Reattach suction set.
28. Pour Trilube through slot in cover plate #55, diagram "B".
REPLACE BY-PASS VALVE
1. To replace the pressure relief valve #27 knock pin #29 through black handle #28.
2. Remove black plastic handle and cap with indexing pin which exposes pressure relief valve.
3. Using a 3/4" open end unthread by pressure relief valve. Inspect. Replace if worn.
REPLACE FILTER
1. To replace the paint filter remove filter bowl #1 from fluid manifold by unthreading counter
clockwise.
2. Remove filter #3 and spring support #4. Most times filter can just be cleaned but if damaged
replace.
REPLACE TRANSDUCER
1. To replace transducer hold wire tube of #31 with plyers and unthread transducer housing
#30 from pump/filter manifold.
2. Remove mounting screws # 25.
3. Remove 4 screws for crank housing cover plate # 55.
4. With a flat blade screwdriver pry pump/filter manifold downward till it clears locating pins
and slide forward but do not remove.
5. Remove 4 screws #40 and Control box cover plate #70.
6. Unplug transducer from circuit board. See diagram "B".
7. Guide transducer wire out of control box.
8. To replace guide replacement transducer through grommet #91 and reconnect to circuit
board.
9. Thread transducer into pump/filter housing.
10. Replacement of transducer requires no calibration of pressure control. To ensure new
transducer functions properly follow Start up procedure.
44