Hydrofarm JUMP START JSFC12KT2 Mode D'emploi page 2

Thank you for purchasing the Jump Start 12"
Lighting System. The highly reflective material
directs light downward, bathing your plants in
full-spectrum light and increasing your growing
success with starts, cuttings, herbs, flowers, or
vegetables.
WHAT'S IN THE BOX
1 - 12" Jump Start lighting fixture with reflector
and T5 HO tube
4 - Extension wireform legs
2 - Lamp socket caps
2 - Stand plates
WARNINGS
• Do not attempt to replace or repair a
damaged power cord.
• To avoid electrical shock, do not expose the
fixture or its components to water or liquid.
• Keep fixture unplugged when not in use.
• Do not operate the fixture in the presence of
explosive or flammable vapors.
• Do not place the fixture near an open flame,
cooking, or heating appliances.
• Do not pull the power cord to disconnect it
from the power source. Grip the plug base.
• This fixture is designed to be operated
indoors only.
• Do not operate the fixture with a damaged
cord or plug. Discard fixture or return to an
authorized service facility for examination
and/or repair.
• Do not run the cord under carpeting or
similar coverings.
• Do not run the cord under furniture or
appliances.
ASSEMBLY
1. Place the plastic caps onto the fixture. Please
disregard this step if the plastic caps are pre-
placed (see Figs. 1 & 1a).
www.Hydrofarm.com
2
INSTRUCTIONS
2. Insert the stands into the plates individually.
Take note that the side with gap lines should
be downward (see Fig. 2).
3. Insert the other side of stands into the holes
on the two mounted plastic caps (see Fig. 3).
Fig. 1a
Fig. 1
Fig. 2
Fig. 3