Publicité
Les langues disponibles
Les langues disponibles
Using the Mounting Disk
WARNING: The mounting disk uses permanent adhesive that is extremely difficult to remove
after it is installed.
To mount the Navus 2 using the disk:
1. Clean and dry the area where you want to place the mounting disk.
2. Remove the backing from the permanent mounting adhesive on the bottom of the disk.
Place the disk in the selected area. Press firmly for several seconds.
3. Pull the lever on the suction cup up (away from the disk). Place the suction cup mount
on top of the disk.
4. Flip the lever down (toward the disk) to secure the suction cup mount to the disk.
Removing the Navus 2 and the Mount
To remove the Navus 2 from the mount, gently pull the Navus 2 off of the mount.
To remove the mount from the mounting surface, flip the lever toward you. Pull the rubber tab
on the suction cup toward you.
Unit 5, The Quadrangle, Abbey Park Industrial Estate, Romsey, SO51 9DL, U.K.
Disk
© 2006 Garmin Ltd. or its subsidiaries
Garmin International, Inc.
1200 East 151
Street, Olathe, Kansas 66062, U.S.A.
st
Garmin (Europe) Ltd.
Garmin Corporation
No. 68, Jangshu 2
nd
www.garmin.com
Part Number 190-00687-04 Rev. A
Road, Shijr, Taipei County, Taiwan
K6860188
Lever
Publicité
