Ga.Ma SALON EXCLUSIVE GC 910 Mode D'emploi page 9

GC910
RECOMMENDATIONS FOR USE:
Before using the hair clipper the hair must be clean and dry. We recommend cutting small quantities of hair at
a time, adjusting the cutting length gradually until finding the one you want. The blades risk getting stuck if too
fast movements are made or if a lot of hair is cut at the same time. It can be used without attachment comb
to trim beard, neck hair and sideburns.
BEFORE USING THE APPLIANCE:
Before charging the hair clipper for the first time we recommend fully discharging the battery and then fully
charging it.
Make sure that the appliance is switched off.
Plug the appliance into the power outlet and then connect it to its adapter. The charging LED will light up
and remain blue for the whole charging process. As soon as the product is fully charged, the LED will go
off. Attention: to prolong battery life, the first charge should be much longer even if the LED is off.
The first charge takes 12 hours. Subsequent charges take about 2 hours. When fully charged, the battery
will last about 60 minutes.
Disconnect the adapter from the outlet once it is fully charged.
The hair clipper may be used connected directly to the power outlet if the battery charge is depleted.
The duration of the battery varies based on usage frequency and times. To increase the lifespan of the
batteries, this procedure should be carried out at least twice every 12 months, discharging the battery
completely and recharging it for the maximum time. If the appliance is not used often, remember in any case
to carry out a charging cycle every so often during the year to keep it working efficiently. On the contrary,
when the charging is finished, do not keep the appliance connected to the mains to prevent the battery from
overcharging and damaging the appliance.
WARNING:
Do not attempt to replace the internal battery of the hair clipper. This can lead to the risk of fire or electric
shock. Tampering invalidates the warranty on the product.
15
CAUTION:
Lubricate the blade before the first use. Read the instructions contained in the section "HOW AND WHEN TO
LUBRICATE THE BLADE"
USE INSTRUCTIONS:
Insert the desired attachment. This operation should always be done with the hair clipper turned off.
Turn on the hair clipper by pressing the (O/I) button.
Turn off the hair clipper by pressing the (O/I) button.
INSERTION OF COMBS:
The supplied combs have two snap on seats. One near the teeth of each comb (Fig. 1) and the other near the
base of each comb (Fig. 2). To insert the combs in the hair clipper, set the snap on base near the teeth of the
comb on the hair clipper blade and then push the base of the comb against the base of the blade head until
you hear a slight click: insertion will be now be completed. Remove the combs using the tab located on the
base of the comb, exerting an outward force.
Fig.1 Fig.2
16