Kicker SOLO-BARIC L7S8 Manuel D'utilisation page 4

Do not install a port opening against a solid surface, such as an internal brace, back-panel or trunk wall,
seat or interior panel of your vehicle. The port opening must remain unobstructed. Use the smallest
dimension of the rectangular port as the minimum amount of space between the port opening and any
solid surface to insure unrestricted airfl ow.
If you prefer an ultra-smooth bass response, you should loosely fi ll your L7 enclosure with poly-fi l
stuffi ng. Ported designs will require covering the end of the port (located inside the box) with grill cloth,
chicken wire, or expanded metal to prevent the poly-fi l from exiting the port. The use of poly-fi l will slightly
decrease effi ciency, but will deepen and extend the low frequency output.
For more advice on box building, refer to your Authorized Kicker Dealer, or click on the Support tab on
the Kicker homepage, www.kicker.com. Please e-mail support@kicker.com or call Technical Support at
(405) 624-8583 for specifi c or unanswered questions.
Figure 3
D
D = 3" x 3" for L7S12, L7S15
D = 2" x 2" for L7S8, L7S10
SEALED ENCLOSURE APPLICATIONS
Sealed Minimum
Model Volume ft
L7S8 .5 (14.16)
L7S10 1 (28.32)
L7S12 1.25 (35.4)
L7S15 2 (56.64)
Panel Dimensions for Minimum Sealed Enclosures using 3/4" (1.9cm) thick MDF (See Figure 5)
Model Volume ft 3
L7S8 .5 (14.16)
L7S10 1 (28.32)
L7S12 1.25 (35.4)
L7S15 2 (56.64)
4
2017 L7 Rev F.indd 4 2017 L7 Rev F.indd 4
D
D
3 (L) Power Handling
450W RMS
600W RMS
750W RMS
1000W RMS
(L) Panel A in. (cm)
11X11 (27.9X27.9)
13.5X13.5 (34.3X34.3)
14.5X14.5 (36.8X36.8)
16.5x16.5 (42x42)
Figure 4
Y
X
Sealed Maximum
Model Volume ft 3
L7S8 .75 (21.24)
L7S10 1.25 (35.4)
L7S12 2 (56.64)
L7S15 6 (169.9)
Panel B in. (cm)
11x9.5 (27.9x24.1)
13.5x12 (34.3x30.5)
14.5x13 (36.8x33)
16.5x15 (42x38.1)
(L) Power Handling
450W RMS
600W RMS
750W RMS
1000W RMS
Panel C in. (cm)
9.5x9.5 (24.1x24.1)
12x12 (30.5x30.5)
13x13 (33x33)
15x15 (38.1x38.1)
11/1/2016 4:13:30 PM 11/1/2016 4:13:30 PM